RS-BA1 IP Remote Control Software

Further advanced dualwatch remote control software

• Low latency provides the same operational experience as using an actual radio plus high quality audio over an IP network.
• Most functions and modes of your transceiver, including interference rejection functions and IF filter settings, can be controlled using CI-V commands.
• Remote power ON/OFF function wakes up the IC-7600 from standby mode.

Interface tailored to Icom transceivers
This Icom exclusive software gives you most functions and modes from your Icom transceiver in your ham shack.

• Several separate windows for CW keyer settings, voice memory, SSB passband settings for both transmit and receive, and filter settings.
• Slider control or tuning knob control screens are selectable for RF power, CW pitch, RF gain, and SQL and AF level.
• Rx Voice recording function.
• View the spectrum scope with the waterfall function. It provides a high speed, high resolution spectrum scope equivalent to the main unit (For a single band on only the IC-7851, 7850 and 7300).

Dualwatch, dual spectrum scope control
The dualwatch operation and dual spectrum scopes with the waterfall functions* can be used on your remote PC. MAIN and SUB spectrum scopes can be observed on the RS-BA1 at the same time. Of course, the RS-BA1 can be used with Icom single receiver transceivers.
* The dualwatch and dual spectrum scope functions are only for the IC-7851, IC-7850, and IC-7610. The spectrum scope functions (single receive) are usable with the IC-7300 and IC-9700.

Most functions can be controlled
Most functions and modes of your transceiver, including interference rejection functions and IF filter settings, can be controlled using the CI-V commands. The following functions are added to the RS-BA1 Version 2.

• Panel size can be enlarged (Normal or large size selectable)
• Indicator click operation to change the settings
• RIT and ∂TX functions • [MUTE] button • SUB dial

Low latency, high quality audio over an IP network
The RS-BA1 offers real-time operation with low latency, high quality audio. You can use the transceiver installed in another room using your home network, or even from a remote location over the Internet*. *A static public IP address or Dynamic DNS is required for the base station (Server) PC, when you configure the remote control system through the Internet.

• CD (including the RS-BA1 instruction manual, the RS-BA1 installer, the USB driver and the USB driver installation guide)
• USB cable (A-B type)
• Installation guides