Total Recall VR Audio Mixer (Accessories)

Ultra low-noise 2 channel audio mixer

• 3.5mm TS and RJ12 connector for each input
• Signal level control (gain) for each input
• Redundant line-level output
• 3.5mm TS and RJ12 connector for each output
• 9-15VDC power source centre negative
• Maximum output signal level: +16dBu (with 15VDC power supply)
• Minimum input signal level: -30dBu
• Input impedance: 100Kohm
• Frequency response: 20Hz-20KHz
• Total harmonic distortion: < .005%

You can use Total Recall VR Audio Mixer to:

• Combine (mix) a stereo audio signals into a mono signal.
• Combine (mix) the transmit (Tx) and receive (Rx) audio signal of a 2-way radio, repeater or base station.
• Combine (mix) any two line level audio signals into a single line level signal.

The Total Recall VR Radio Mixer requires a 9VDC-12VDC power pack to power the mixer. This power pack is NOT supplied with the unit.

A rack mount shelf is available for installation of multiple Total Recall VR Audio Mixers into an equipment rack. Use the shelf to install 4 Total Recall VR Audio Mixers so that the whole assembly is 1RU high

.

Alternatively, use the shelf to install 16 Total Recall VR Audio Mixers so that the whole assembly is 3RU high.